The differance between Differential sticking and Mechanical stucking

 The difference between mechanical stuck and differential stuck

This question was asked in one of the famous oil companies an
: the answers were as follows
 Differential sticking mostly has to do with mud cake. The formation that is permeable has a bunch of built up cuttings and they are getting you stuck. If that is the suspected cause I have found slowing down pump rates gets you out of it best. Mechanical stuck means anything like a tight hole that BHA or something is stuck in. This could also be key seats, cutting beds in lateral, high dog legs with stiff assemblies and stuff like that
Another Answer
Loss of circulation will cause differential sticking. Differential sticking happens because the hydrostatic pressure is greater than the formation pressure, this is why you must always keep the pipe moving when your BHA is in formations known to have problems with loss of circulation

The differance between Differential sticking and Mechanical stucking
Another Answer
Differentially stuck can be caused by an overbalance and a filter cake that is in the process of becoming one causing a suction against the wellbore and also too much filter cake may also cause the string to become differentially stuck. Mechanically stuck can be caused by many other hole problems: unconsolidated formations, junk in the hole, ledges, doglegs and so on. Hope this helps

Another Answer

Differential stuck is caused by the difference of mud column pressure and formation pore pressure. It is similar to when you cover a drain with your hand and feel it being sucked. this kind of stuck easily identified by the stucked pipes (no rotation, no reciprocation) and no restriction on circulation. When this stuck happens, then mud cake and pipe diameter will make it worse. The only way to fix it is by lowering mud weight and/or spotting free pipe agent pill

Another Answer

Differential stuck is worse usually, especially in high-pressure areas where you can't lower the mud weight

Another Answer

Mechanical stuck: due to formation collapse and mud circulation

. mostly no return

Differential stuck due to overbalance and mud cake so one side of drill pipe stuck to formation, however, mud circulation still have return

Another Answer
Mechanical stuck refers to being stuck by things such as key seats, unclean hole, or falling information. Hydrostatic sticking happens when there is an underbalanced formation that begins taking drilling fluids. The fluid rushing into the formation can such your drill string up against it. For example, fill a tub of water. Remove the drain plug and the place your hand over the hole. Notice how your hand becomes stuck to the drain. That is hydrostatic sticking

Another Answer

Differentially Stuck is due to a pressure differential between mud and formation. Mechanical is everything else basically

And I see

Differential sticking occur during drilling when the hydrostatic pressure is greater than the formation pressure which causes pushing a drill string into a filter cake of permeable formation

when the Differential sticking occur moving the pipe string
in the downward or upward direction is impossible
but free circulation is easily established

Mechanical sticking there is no circulation and rotation

Share this

Related Posts

Next Post »